Three-Point Turn and Roadside Stop Practice

Practise the Ontario G2 roadside stop and three-point turn with handbook-based feedback.

Rules year: 2026Last verified:

Pull over at the right and stop. Then turn around using a three-point turn.

Road width

How to do it

  1. Check mirrors and signal right before slowing. Stop parallel and close to the right curb.
  2. Turn off the signal, turn on hazards, shift to P and set the parking brake.
  3. Turn hazards off, signal left, check mirrors and left blind spot, then turn sharply left.
  4. At each stop, check both directions. Reverse once with sharp right steering, then move forward.
  5. Check mirrors and accelerate smoothly in the new direction.

Keyboard

↑
Gas
↓
Brake
←→
Turn the wheel (it stays where you leave it)
X
Centre the wheel
DRP
Drive, reverse, park
QE
Left / right signal
M
Check mirrors
ZC
Look over left / right shoulder
B
Parking brake
H
Hazard lights
V
Top view

Sources

How scoring works

Scoring follows the roadside stop and three-point turn sections of the Official MTO Driver’s Handbook. The handbook specifies about 30 cm from the curb. The 6-degree parallel angle, 10-degree final heading, six-second check freshness, 4 m/s² braking limit, 3 m/s² acceleration limit, 25-metre resume distance, normal speed threshold and near-curb turn stopping distance are practice standards.

Disclaimer

Practice only. The score is not an official road test result and the simulation is simplified. Study the Official MTO Driver's Handbook and practise in a real vehicle with a qualified driver.

Was this tool helpful?